Reviews for Seastar / Uflex Support Bracket Puller

wotkd well just one problem the resesed cup on the end of threaded shaft is not secured well and poped off falling into weater Managede to still use the tool but much more dificult with out that recessed cup

The tool works well…. But said by all other reviews the jaws are to wide and once you start to tighten the pulled it slips and will mess up the bracket. Just a heads up

This product works as advertised. I would not have been able to remove my steering bracket with out this tool. I had purchased 2 other pitman pullers prior to purchasing this item. Both of those pitman products fell short and would not fit over the bracket. I bought this, and had some reservations at first that it would fit. At first install it was a bit loose, but as I tightened the bolt, the teeth grabbed more and more. I had to heat the bracket slightly to break the salt corrosion. After that came off like melted butter.

Puller did work but did not fit on the lip well 1 side of puller ran up the side of bracket & gouged it just be careful when using & putting pressure on the arm when using . It doesn’t fit correctly it would be easy to make the tool adjustable they should try & modify the tool.

This is a well made tool and can save a lot of hassle. Just be sure it fits your application. Good customer service as well.

Works about 30% of the time , Jaws are to wide and slips causing gouging on support bracket, think marine tech should recall them and correct the problem.

The puller worked but it is not sized properly. It seems that the jaws are just a bit too wide and does not grab the support arm properly. It did do the job but gouged the support arm and I had to grind down the damaged area and re paint it. I also purchased the Trim/Tilt Pin Wrench Set (K1001) and the tool for the steering cylinder end caps did not fit very well. The other 2 tools fit perfectly for the motor trim and tilt.

Absolutely the right tool for the job. I wish more tools were as well thought out and made as this

I did not want to go the heat and hammers route on my steering. Found this tool in a video and called up Marine Tech. I ordered the tool next day because I had to get my boat going. It was at my house next day for less than $60. I had the brackets off in less than 10 minutes with no beating or banging and only a couple of scratches on the brackets. Highly recommend!

Good quality as described would recommend